← Home
🔧 Keep it rolling
Board care and setup
Set up a complete, tighten trucks, clean bearings after the rain, when to change wheels, grip and deck, with a maintenance log.
Setting up a complete
- Grip tape: peel, lay from the nose, press out bubbles, file the edge with the side of a screwdriver and cut with a sharp blade.
- Hardware: bolts go in from the top; trucks with the kingpins facing the middle of the board.
- Wheels: tighten the axle nut until the wheel stops wobbling, then back it off a quarter turn so it spins freely.
- Truck tightness: loose turns more, tight is more stable. Turn the kingpin nut a half turn at a time.
- A skate tool (T-tool) does everything. Keep one in your bag.
After rain and puddles
- Water rusts bearings and makes decks soft and heavy. Avoid wet skating in the rainy season, or keep an old board for it.
- If your board gets wet: dry it with a cloth, stand it on its tail in the shade (not the sun), and spin the wheels so the bearings dry.
- Clean bearings: remove the shields, soak in isopropyl alcohol, dry fully, then add one or two drops of skate bearing lubricant.
When to replace
- Deck: when it loses its pop, chips deeply, cracks or turns soft and soggy.
- Wheels: flat spots, cones or cracks. Rotate them every few weeks so they wear evenly.
- Bearings: noisy or slow after cleaning.
- Bushings: cracked or squashed; cheap to replace and change how the board turns.
- Grip: smooth, worn patches where your feet go.
Maintenance log
- Check bolts and axle nutsEvery 7 days · never loggedDue
- Clean bearingsEvery 45 days · never loggedDue
- Rotate wheelsEvery 21 days · never loggedDue
- Check bushingsEvery 60 days · never loggedDue
- Clean grip tape (eraser or grip gum)Every 30 days · never loggedDue
- Inspect deck for cracks and razor tailEvery 14 days · never loggedDue
